How to replace a Polaris Pool Cleaner Tire

Things You’ll Need

• Polaris Pool Cleaner Tire
• Polaris Pool Cleaner Wheel
• Polaris Pool Cleaner Wheel Screw
• Polaris Pool Cleaner Wheel Washer

Step 1

First turn off your booster pump and disconnect from the dedicated pressure cleaner line from pool port, then remove your cleaner from the pool. Replacement Polaris 280 Pool Cleaner Tire part #: 3260-C010

Step 2

The screw for Polaris Cleaner Wheel is located here, you will require a flat-head screwdriver to remove it. Replacement Polaris 280 Pool Cleaner

Step 3

With the screw out of the way, you can now take the wheel washer and place to side for later. Replacement Polaris 280 Pool Cleaner Wheel Washer part #: 3260-C064

Step 4

Now you may lift the pull wheel straight off its axle. Replacement Polaris 280 Pool Cleaner Drive Shaft part #: 3260-C086, Rear Axle part #: 3260-C065

Step 5

Now to remove the tire from the wheel, do this by pulling the lip on the outside of the wheel up and over the wheel until it is off. Replacement Polaris 280 Pool Cleaner Tire part #: 3260-C010

Step 6

Place the new tire onto the wheel in the reverse fashion you had taken the damaged one off, sliding the lip of the tire over the wheel.

Step 7

With your Polaris Cleaner Tire installed place the wheel onto the Polaris Cleaner Axle, spin it to check the movement is free and clear.

Step 8

Place the washer on top of the wheel bearing securing the wheel with the Polaris Wheel Screw. Test the movement of the wheel by spinning forward and backwards to check for any obstructions. If your wheel spins correctly then you may resume enjoying using your Polaris Pool Cleaner.